Engineering Lab Workshop Equipments

Tilting Flume (6 Meter)

Model No – NEE-25-01-19-0014

The Tilting flume consists of a channel of size as in specifications. At the inlet a flow steadying section is provided so that there will be fewer disturbances at the test section. The gates provided at the upstream & downstream of the test section help to regulate the depth of flow. Depth measurements can be achieved with the help of a hook or point gauge mounted on a trolley which gives longitudinal and transverse movement. The slope of the bed can be adjusted to give positive or negative slopes.

RANGE OF EXPERIMENT:-

• Study of open channel flow with slope
• Study of specific energy curve
• Study of hydraulic jump
• Study of Nappe profiles over a sharp crested weir
• Calibration of sharp crested, Broad crested and ogee weir
• Calibration of a Venturiflume
• Study of flow under the sluice gate

SPECIFICATION:-

• • A hydraulic flume of c/s 200×300 mm & 6000 mm length with transparent window on either sides of 1800 mm length.
• Sliding gates one at upstream and other at the downstream side.
• Screw jack for change of the slope of the flume.
• A Sump tank of sufficient capacity.
• Supply tank with waves damping arrangement.
• A 3 H.P. centrifugal monoblock pump.
• An Orifice meter with manometer to measure the discharge. Inlet/throat dimensions: 50/25 mm respectively.
• Trolley with point gauge for level measurement.
• Models supplied:
  • Sharp crested weir (crest length 200 mm)
  • Broad crested weir
  • Ogee weir or spillway.
  • Venturi flume

SERVICE REQUIRED:-

• Suitable Water supply.
• Suitable floor space to mount apparatus.
• 15 amps Single Phase Electrical Connection